| Number of stage: |
1 thru 10 (cast) |
| Inlet connection: |
4" (102 mm) flange,
matches 125# ANSI |
| Outlet connection: |
2.5" (63.5 mm) flange,
matches 125# ANSI |
| Operating speed: |
3600 rpm in direct drive (60Hz) |
| Lubrication: |
Grease lubricated |
| Impeller diameter: |
14" (355.6 mm) |
| Impeller tip speed: |
246 f/s (75 m/s) |
| Drive: |
Direct drive or V-belts |
| Vibration tolerance: |
1.5 mils peak-to-peak (5.4 mm /s) |
| Shaft end: |
0.86" (38 mm), inlet end drive standard |
| |
Materials of Construction |
| Heads, bearing housings: |
Cast iron ASTM A-48 Class 35B
or equivalent |
| Sections: |
Cast aluminium ASTM 356
or equivalent (cast iron optional) |
| Tie rods: |
1/2" (12.7 mm) diameter
cold drawn steel A60 |
Join sealing
compound : |
RTV IS502 Silicone |
| Seals (air): |
Two graphit rings each end |
| Seals (gas): |
Four carbon rings each end
with inert gas injection |
| Bearing: |
Ball bearings 6410 C3 THT
per AFBMA B10 STANDARD |
| Shaft: |
AISI 1038 Carbon Steel or equivalent |
| Impellers: |
Cast aluminium ASTM 360
or equivalent |
| Motor pedestal : |
Structural steel |
| Base pads : |
Korfund Elasto-rib or equivalent |
| Noise level: |
In compliance with OSHA standards
when machine is fully piped
(certified tests available) |
| |
|
